* Most metal doors come already primed, but usually not in the color you should be starting with. (Practice with the graining tool on a piece of scrap following the instructions in Step 3 until you feel comfortable using it) * You will need: a graining tool, clean, dry, lint-free cloths, and clean, dry synthetic brushes. Allow approximately 6 to 8 hours between coats for the stain to dry. * To darken the color, apply additional coats of Gel Stain by following the instructions above. * Allow stain to dry approximately 6 to 8 hours. * Gel Stain, while wet, is easily removed with a rag moistened with mineral spirits. Areas of heavier coats should be evened out before moving to a new section. * Minwax® Gel Stain remains brushable for an extended period of time. Always make final brush strokes in the direction of the embossed grain. * Using a high quality natural bristle brush, spread a thin, even coat over the entire surface, starting with the raised panel sections.
This will thin Gel Stain into a syrup-like consistency. Then, reseal the container and shake Gel Stain vigorously for at least 30 seconds. * Before applying, stir Minwax® Gel Stain to break up its gel consistency. Use a rag moistened with mineral spirits to remove dirt and scuff marks left on the door during shipping and handling.
#Gel stain colors free#
* Make sure the door surface is free of all dirt and foreign matter. The door should not be closed during the drying/curing process. If you are finishing a pre-hung door, allow enough time in each of the application steps for the door to dry (at least 6 to 8 hours) to avoid sticking. For exterior use we recommend Minwax® Helmsman® Spar Urethane.įor ease of staining and finishing we recommended that you finish the door before installation. For interior wood use Minwax® Fast Drying Polyurethane or Minwax® Polycrylic Protective Finish. * After 24 hours, apply a Minwax® protective clear finish. Allow the stain to dry 8 to 10 hours between coats. * To darken the color, apply additional coats of Minwax® Gel Stain following the instructions above. Wait 3 minutes and, using a clean rag, wipe with the wood grain to remove the excess. * Apply a liberal amount of Minwax® Gel Stain evenly with a brush or rag. * Test stain on hidden area to verify desired color.
* Before use and occasionally throughout project, stir Minwax® Gel Stain until creamy. Apply Minwax® Gel Stain within 2 hours of pretreatment. * Apply Minwax® Pre-Stain Wood Conditioner, allow to penetrate for 5-15 minutes, then wipe off excess. * To help ensure even stain color penetration and beautiful results, pre-treat soft or porous woods such as pine, maple, alder and birch with Minwax® Pre-Stain Wood Conditioner. * Make sure the surface is clean and free of dirt, grease and old coatings.
0 kommentar(er)
